The US Navy Body Fat Formula: How It Works

Where the US Navy circumference method came from, the formulas for men and women, how to measure correctly, and how accurate it is.

The US Navy body fat formula estimates body fat percentage from a few tape measurements and your height. It needs no special equipment, which is why it is used for military fitness standards and in many online calculators.

Our body fat calculator uses this method. This guide explains where it comes from and how to get the most reliable result.

Try the Body Fat Calculator. Body fat percentage with the US Navy tape method

Open the calculator

Where the formula came from

The method was developed by researchers at the Naval Health Research Center in San Diego. Hodgdon and Beckett published the equations in 1984. They measured body fat in a large group of Navy personnel using underwater weighing, the most accurate method then available, and looked for simple tape measurements that predicted it well. Neck, waist and, for women, hip measurements, combined with height, turned out to work best.

The formulas

With measurements in centimeters:

Men: %BF = 495 ÷ (1.0324 − 0.19077 × log10(waist − neck) + 0.15456 × log10(height)) − 450
Women: %BF = 495 ÷ (1.29579 − 0.35004 × log10(waist + hip − neck) + 0.22100 × log10(height)) − 450

These equations first estimate body density, then convert density to body fat percentage using the Siri equation, which is where the 495 and 450 come from.

Example

A man 180 cm tall with a 40 cm neck and a 92 cm waist:

  • waist − neck = 52 cm
  • body fat ≈ 19.8%, or about 20%
Advertisement

How to measure

Accuracy depends mostly on measuring consistently. Use a flexible tape measure on bare skin, snug but not compressing the skin.

Measurement Where Who
Height Standing straight, without shoes Everyone
Neck Just below the larynx (Adam's apple), tape sloping slightly down toward the front Everyone
Waist (men) Horizontally at the level of the navel Men
Waist (women) At the narrowest point of the abdomen Women
Hips At the widest point of the buttocks Women

Tips:

  • Measure in the morning, before eating.
  • Breathe out normally and relax your stomach; do not pull it in.
  • Take each measurement two or three times and use the average.
  • Use the same tape and the same person, if possible, each time.

How accurate is it?

Compared with laboratory methods such as DEXA scans, the Navy method is typically within a few percentage points for most adults. It tends to be less accurate for:

  • very lean or very muscular people, especially those with a thick neck
  • people with an unusual fat distribution
  • older adults

Because individual errors can be a few points either way, it is best used to track change over time, measured the same way each month, rather than as an exact figure.

Comparing methods

Method Equipment Typical accuracy Notes
US Navy tape method Tape measure Moderate Cheap and repeatable
Skinfold calipers Calipers and a trained tester Moderate Depends on the tester's skill
Bioelectrical impedance (smart scales) Scale or handheld device Variable Affected by hydration
DEXA scan Clinic equipment High Also measures bone density

To see where your result falls, read healthy body fat percentage ranges.

This guide is general information, not medical advice. Talk to a doctor, midwife or registered dietitian about your own situation.