Negative Split Pacing: Why Running the Second Half Faster Works

What a negative split is, why many runners aim for one, how to plan race splits for a 5K, 10K, half or full marathon, and common mistakes.

A negative split means running the second half of a race faster than the first. An even split means running both halves at the same pace. A positive split means slowing down in the second half, which is what happens to many runners who start too fast.

Use our running pace calculator to work out your target pace and split times.

Try the Running Pace Calculator. Pace, finish time or distance for runs and races

Open the calculator

Why start slower?

Starting at or slightly below your goal pace has several advantages:

  • Energy use is more efficient. Going out too fast burns through stored carbohydrate quickly, which can leave you struggling late in longer races.
  • Your body warms up. The first kilometers act as an extended warm-up, especially in shorter races where the warm-up may have been brief.
  • It feels better mentally. Passing people in the second half is far more encouraging than being passed.
  • Small savings early prevent big losses late. Running the first kilometer 15 seconds too fast can cost much more than 15 seconds later on.

Many record-setting performances at longer distances have been run with even or slightly negative splits, which suggests that steady pacing is efficient.

How much faster should the second half be?

Usually only a little. For most runners, a negative split of around 1% to 3% is plenty. For a 50-minute 10K, that means running the first 5 km in about 25:15 to 25:30 and the second in about 24:30 to 24:45.

Trying to run the second half dramatically faster usually means the first half was too slow.

Advertisement

Planning your splits

Step 1: decide your goal time and work out the average pace. For a 2:00:00 half marathon, the average is about 5:41 per km (9:09 per mile).

Step 2: plan to run the early part a few seconds per km slower than average, the middle at goal pace, and the final part a little faster.

Example: half marathon in 2:00:00

Section Distance Target pace Approximate time
Start 0–5 km 5:46 per km 28:50
Middle 5–16 km 5:41 per km 62:31
Finish 16–21.1 km 5:35 per km 28:28
Total 21.1 km about 1:59:49

The calculator gives the even-pace splits for any distance, which you can then adjust.

Pacing by distance

  • 5K: close to even pacing works well. Avoid sprinting the first few hundred meters.
  • 10K: settle into goal pace in the first kilometer or two, then push in the final 3 km.
  • Half marathon: be patient for the first 5 km; the race really starts after 15 km.
  • Marathon: the first half should feel comfortable. Many runners who slow sharply in the last 10 km went out too fast.

Common mistakes

  1. Getting carried away at the start. Adrenaline and crowds make fast starts easy. Check your watch in the first kilometer.
  2. Ignoring the course. Hills, wind and heat all affect pace. Aim for even effort on hilly courses, not even pace.
  3. Chasing lost time. If you fall behind early, trying to make it all back at once usually backfires. Gradually return to goal pace.
  4. Never practicing. Rehearse race pace in training, including some runs where you finish faster than you start.

Practicing negative splits in training

  • Progression runs: start easy and finish each third of the run a little faster.
  • Out-and-back runs: run out at an easy pace and aim to return a little quicker.
  • Fast finishes: run the last 1 to 2 km of a regular run at goal race pace.

For the basic math of pace, finish times and conversions between km and miles, see how to calculate running pace.

This guide is general information, not medical advice. Talk to a doctor, midwife or registered dietitian about your own situation.